How to read a soil survey for solar leasing

Freshly tilled, bare soil field bordered by trees under a blue sky.

A landowner hands you a lease proposal, and somewhere in the due diligence pile sits a soil map nobody on the call can parse. That's normal. NRCS built the Web Soil Survey for conservation planning and crop insurance underwriting. Reading it for agrivoltaic siting means asking a different set of questions of the same data. Here's what the report is telling you.

Start with the map unit, not the color

Pull up Web Soil Survey, draw your AOI around the parcel, and generate the AOI Soil Map report. The map will shade the field into two or three colors. Ignore the colors at first and look at the map unit symbols instead, things like "MnA" or "WaB2." Each symbol maps to a map unit name in the legend, and that name gives you the dominant soil series and the slope range, something like "Miami silt loam, 0 to 2 percent slopes."

A single map unit is rarely one uniform soil. It's a mix of components, usually a dominant soil series at 70-85% of the unit and one or two minor components that behave differently. For solar leasing purposes, the dominant component is what you design around, but a minor component with a high water table or shallow bedrock is worth a site visit before you commit acreage to racking.

Two numbers on the report matter more than the rest combined: the Land Capability Classification and the drainage class. Capability class runs I through VIII, with I being the best cropland and VIII being land that shouldn't be farmed at all. A parcel sitting at Class II or III with moderate limitations is often the sweet spot for agrivoltaics. Class I ground is the ground a co-op least wants to see go under racking, and the pushback at a community meeting usually starts there.

What changes your layout decision

Drainage class and depth to a restrictive layer drive the real engineering questions. A soil series marked "somewhat poorly drained" or "poorly drained" means standing water after a wet spring, which matters for pile foundations and for whether sheep or row crops can work the ground between arrays. Depth to restrictive layer tells you how far down you hit bedrock or a dense clay pan before a pile won't seat. Shrink-swell potential, listed under soil physical properties, tells you whether the clay content will heave posts over a few freeze-thaw cycles.

None of this comes with a number that says "lease here." It's a set of limitations you weigh against what the co-op is already growing. A soil that's marginal for corn can still work fine for sheep grazing under single-axis trackers, and a field with a documented drainage limitation might be exactly the acreage where a developer and a landowner stop treating "good cropland" as one category.

Where the soil survey stops answering questions

The survey tells you what the soil can theoretically support. It doesn't say what's been planted there the last five seasons, where the parcel lines fall relative to a feeder or substation, or which fields a co-op member already wrote off as too wet to bother with. That gap is usually where a developer's map and a co-op's map stop agreeing, and it's the reason these conversations drag into a third or fourth meeting before anyone picks a parcel.

Pulling the soil data gives a siting review its first filter, the limitations that rule fields out before anyone drives out to look at them. Pairing it against crop type and yield history tracked field by field turns a soil survey printout into a short list you can bring to a landowner without redoing the homework twice. Agrisolar Siting builds a seasonal candidate parcel map from satellite imagery and parcel-level crop and yield records, so the drainage and capability-class limitations in the soil report line up against what's actually growing out there, not a county average. If your soil survey and your yield data keep pointing at different fields, that's worth a look.

Request early access

← Back to the blog